Media:Electronics Autographed:No Memorabilia:No Shipping Weight (lbs):1.1 Dimensions (in):3.5 x 1.5 x 5.3 Legal Disclaimer:Warranty does not cover misuse of product.
Product Description Typically, the speaker wire that's included with all-in-one home theatre systems doesn't come with connectors. Over time, the exposure to air causes the bare copper wire to corrode. That's why THX, the industry leader in sound quality certification for movie theatres, collaborated with Monster Cable to create connection standards specifically for home theatre speaker connections.Monster THX connectors ensure the highest quality speaker connections.
Puny MonsterJanuary 26, 2008 These pins are adequate only for lower power connections - those using #12 AWG and smaller wire sizes. The barrel into which the wire is inserted for crimping is too small to accommodate #10 Monster Cable.
Color coded speaker wiresDecember 28, 2007 I did not use the pins included here but did want these to color code my speaker wires. I used the color coding provided on the packaging and also used these to designate which wire of the pair was "+". I put the marker on the "+" wire so it is easy to know which wire goes where.
I wish there was a package that just offered the rubber color markings without the pins at a reduced price.
Low endDecember 28, 2007 0 out of 3 found this review helpful
You get what you pay for. Needless to say I didn't get much. These are made for low end small gauge wires for equiptment that is of the same calibur. Oh well.
Not for large gauge wiresDecember 12, 2007 2 out of 2 found this review helpful
I am using 12 gauge wire for all my speaker runs and wanted this type of connector to terminate them to a pair of Yahama NS1000M speakers. The NS1000Ms are older speakers that use a clamp type terminal. The 12 gauge wire will not fit in the solder cup on the THX speaker pins. Yes you can trim the wire down and with some careful soldering make them work but the color coded caps are not large enough to accmodate the 12 gauge wire. The specs should show the maximum usable wire size but do not.
Better than bare wire.October 31, 2007 1 out of 1 found this review helpful
I bought these connectors to terminate the speaker wire when I hooked up my Onkyo SKS-HT540 speaker system. On the receiver end of the wires I used banana plugs and on the speaker end I used these bad boys. I really probably would have preferred to use plugs on both ends but the speakers in the Onkyo system that I bought have spring clip connectors and since I wanted to avoid bare wire ends I went with these. I used 12 gauge wire and although it was a snug fit for these connectors it worked out well. The only thing that could have been better would have been if the pins were angled instead of straight so that the didn't stick out as much behind the speakers. Monster does make the angled speaker pins, but I found that they were significantly more expensive so I went with these and am glad I did.
Select Language
Copyright 2007 www.onlinedigitalshop.info All Right Reserved
